senorskitzo1337
17332
4
3
This is on a wall that used to be an exterior wall ~40 years ago until an addition was added. Seems like it has plenty of other studs for support, but don't necessarily trust my judgement.
How do I reattach it if I rip it out and replace it? Pocket holes? Top plate is not accessible and probably doubled.
koyote2033
Put a sister stud in immediately next to it BEFORE removing the old one. This will allow the wall to remain supported as you do the repair. You can even tie the new stud to the sister after and have more support than you did previously. GL and measure twice
foxpotate
I'd recommend temporary bracing while doing that maneuver. Just in case.
[deleted]
[deleted]
koyote2033
If you're pre drilling, why are you using nails still? You should use screws at that point to dig themselves into the wood better. For nails, they need to be encased in wood to ensure they stay in place when the would expands and contracts as it dries out and cures more. If you want to use nails still, just tap the nails in their spot on the stud beforehand, get the stud in place, hammer the nail in that the woods holding for you. EZ. Can do that with an impact driver and screws even easier.
koyote2033
Like there's a good reason that guide you linked doesn't mention pre-drilling. It even describes how to start the nail like I suggested before actually installing the stud (though, it assumes you're installing the stud immediately in the guide)
wildwestpb
I’d put a temp stud in there to support the wall until the new corner stud is installed.
senorskitzo1337
Thanks, and use pocket holes on both ends? Should I replace the insulation while it's open, or waste of time/money?
wildwestpb
I’d use pocket holes, and for insulation if it’s interior now you don’t need to, but it will help keep rooms more comfortable by doing so. Fiberglass or fire retardant spray foam would be good choices.