theGiddyNorse
2656
16
3
Undershelf controller clips, headset/headphone hanger, and a tube to cram lens cleaning cloths in to keep it dust free.
I printed the base with undersized holes, so the aluminum rods fit really tight. Base gets screwed to wall, then the "shelf" slides onto those. I bent one rod out slightly, so you have to squeeze them together a little to slide the shelf on, the pressure of the bent rod then keeps the shelf from sliding off.
Made for a nice clean look.
The center cutout keeps the top strap from interfering with the headphone hooks on the end.
It all fits tidy and secure. Easy to get geared up too: put headphones around neck, put on headset, put on headphones, grab controllers. This setup is just outside of my guardian so I can see what I'm doing while putting everything on/taking it off.
These controller hangers are really convenient to use, and oh so satisfying.
outtaleftfield
Would you be willing to print and sell me a set? (the holders!)
tinydog
Very nice!
SterlingArcherSecretAgent
That looks really great. Though I'd be worried about breaking the controller halos - they're not as strong as you might think.
theGiddyNorse
I’ve actually been concerned about that also, so there’s likely a re-design coming.
AustinJolly
This is awesome, great job. I have a 3D printer and a Quest 2 also. This gives me some ideas.