3744 pts ยท October 16, 2019
https://www.reddit.com/r/cyberDeck/comments/ftbcwh/my_cyberdeck_weyland_corp_edition/
keyboard will be replaced and case will have semiotic standard signs
remix of https://back7.co/home/raspberry-pi-recovery-kit - changed quite some bits - still not finished
My fingercups were bloody..and tbh it was really not enough sanding at the end but I really wanted to progress.
Canon 3200D with a 50mm prime lens
he is around 40cm tall
...and he can move his eyes up and down so he not always sad!
it was - I was screaming inside *a lot*
He has a good life here - you should see him when he is chased by our crawling baby son :-)
Same here - it is actually a present for my little baby-son!
It's not! There are 2 motors that control the eye movements :-) He is just sad in his idle / resting position!
Each side has actually 105 single parts.
https://www.thingiverse.com/thing:3703555> and my make is https://www.thingiverse.com/make:736018
CR10s 0.12 resolution
great! well done!
np, yeah I learned from the past! :-)
Thanks you!
He has to be sad!
that is actually my next-next project!
yes it has! I added several songs and voice snippets that can be triggered from the web-interface
Thanks guys - this build took a while but liked how it came out
Printed on CR10S
https://www.reddit.com/r/cyberDeck/comments/ftbcwh/my_cyberdeck_weyland_corp_edition/
keyboard will be replaced and case will have semiotic standard signs
remix of https://back7.co/home/raspberry-pi-recovery-kit - changed quite some bits - still not finished
My fingercups were bloody..and tbh it was really not enough sanding at the end but I really wanted to progress.
Canon 3200D with a 50mm prime lens
he is around 40cm tall
...and he can move his eyes up and down so he not always sad!
it was - I was screaming inside *a lot*
He has a good life here - you should see him when he is chased by our crawling baby son :-)
Same here - it is actually a present for my little baby-son!
It's not! There are 2 motors that control the eye movements :-) He is just sad in his idle / resting position!
Each side has actually 105 single parts.
https://www.thingiverse.com/thing:3703555> and my make is https://www.thingiverse.com/make:736018
CR10s 0.12 resolution
great! well done!
np, yeah I learned from the past! :-)
Thanks you!
He has to be sad!
that is actually my next-next project!
yes it has! I added several songs and voice snippets that can be triggered from the web-interface
Thanks guys - this build took a while but liked how it came out
Printed on CR10S